Near the tip of the nozzle is a small hole, and a small pipe leads back from the hole into the handle. Suction is applied to this pipe using a venturi. When the tank is not full, air is being drawn through the hole by the vacuum, and the air flows easily. When gasoline in the tank rises high enough to block the hole, a mechanical linkage in the handle senses the change in suction and flips the nozzle off.
Here's a way to think about it -- you've got a small pipe with suction being applied at one end and air flowing through the pipe easily. If you stick the free end of the pipe in a glass of water, much more suction is needed, so a vacuum develops in the middle of the pipe. That vacuum can be used to flip a lever that cuts off the nozzle.
The next time you fill up your tank, look for this hole either on the inside or the outside of the tip.
How much do you know about fleet fuels? Keep reading to to learn about transportation and discover 5 Environmental Solutions for Fleet Fuels.
Related HowStuffWorks Articles
- Gas Prices Quiz
- How Oil Drilling Works
- How Oil Refining Works
- How Gasoline Works
- How Hybrid Cars Work
- How Fuel Cells Work
- How Electric Cars Work
- How the Hydrogen Economy Works
- Is the United States addicted to gasoline?
- What speed should I drive to get maximum fuel efficiency?
- What is the difference between gasoline, kerosene, diesel fuel, etc.?
- What is the Strategic Petroleum Reserve?
- How much extra gasoline would Americans use if daytime running lights were mandatory?
- What does octane mean?
- What is the problem with MTBE in gasoline?